Table of Contents
Advertisement
JANUS 2010 Hand-Held Computer User's Manual (4MB)
code39
nugget
To copy a file from a directory on the host computer's drive C to the reader's
drive E, type this command on the host computer:
copy c:\shared\data\accounts.txt i:\accounts.txt
Interlnk System Requirements
Your host computer and reader must meet these requirements to run Interlnk
and Intersvr:
• A serial port is available on the host computer and reader.
• The host computer is running DOS 3.0 or higher.
• The client has 16K of free memory.
• The server has 130K of free memory.
• The reader is connected to the host computer through a communications
Installing Interlnk on the Host Computer
You need two files to run Interlnk:
INTERLNK.EXE The device driver that you load into the client's memory.
INTERSVR.EXE The program that you run on the server.
You must install those files on the host computer before you can run Interlnk
or Intersvr on the host. You can install the files from either the
MS-DOS Programs companion disk 2 or the reader's drive D.
To install Interlnk on the host computer from companion disk 2
1. On the host computer, make sure that the current working directory is the
2. Insert companion disk 2 into a disk drive on the host computer.
3. Copy INTERLNK.EXE and INTERSVR.EXE from companion disk 2 to the
6-26
helconital
dock or optical link adapter. If you use the communications dock, you must
connect the dock to the host computer with a 3-wire (2, 3, and 7) cable for
Interlnk to operate properly.
directory where you want to install the Interlnk files.
host computer.
Advertisement
Table of Contents
