Table of Contents
Advertisement
Adjusting the Mic Input Level
On the MODEL BANK top screen, press the [ Ë ] button once to switch
to the VD SETTINGS screen.
Follow the steps below to adjust the mic input level.
1 .
Connect a microphone to the rear panel MIC IN jack.
NOTE
The JUNO-X supports dynamic microphones and electret
condenser microphone (mono). It does not support condenser
microphones.
2 .
Set the rear panel MIC IN [GAIN] knob to
approximately the center position.
1 .
Press the [MODEL BANK] button.
Press the [ Ë ] button.
1 .
The VD SETTINGS screen appears.
2 .
On the VD SETTINGS screen, make fine adjustments
to the MIC GAIN.
Sing into the mic at your usual volume. The input level is shown at
the top right-hand part of the VD SETTINGS screen.
Adjust the MIC IN [GAIN] knob so that the input level indicator is at
the appropriate level.
Input level is too high
Input level is correct
Input level is a little low
* For model expansions other than the Vocal Designer/VOCODER,
the mic sound is output from the JUNO-X.
If you aren't using the mic with model expansions other than the
Vocal Designer/VOCODER, set "Mic Thru" to "OFF" in the MENU Ó
SYSTEM screen.
* You can use a controller to switch between the Vocal Designer/
VOCODER sound and the unaltered sound from the mic. See the
"VOC/MIC" item of "List of functions that can be assigned to the
controllers" in the "JUNO-X Parameter Guide" (PDF) for details.
Using the Vocal Designer Model Expansion
7
Advertisement
Table of Contents
