Table of Contents
Advertisement
Troubleshooting
5. Using clean water, completely remove the cleaning
solution from the top and bottom of the awning
fabric. Rinse thoroughly.
6. Repeat the process as necessary.
7. Verify that the awning fabric is dry before closing the
awning.
4.3 Repairing the Awning Fabric
NOTICE: Never close the awning when vinyl liquid
patch (VLP) is wet. Damage to other parts of the awning
fabric (melting through layers) can occur.
q
9 Repairing the Awning Fabric
VLP
q
To repair a pinhole or a spot flaked off of the coating:
1. Apply a very small amount of VLP to a cotton swab.
2. Gently roll the cotton swab around the pinhole.
The VLP melts the coating (on the fabric) and fills in
the pinhole so it blends with the vinyl color.
3. Verify that the VLP is dry before closing the awning.
VLP is available from Dometic Corporation.
I
8
w
Pinhole Tear
w
5 Troubleshooting
Problem
Possible Cause
The awning is
disconnected from
the power source.
The RV or power
source breaker is
tripped, or the fuse
is blown.
The awning motor
does not respond
A power line switch
to the wall switch
is off, or the ignition
operation.
disconnect switch
is ON.
The RV battery has
discharged.
The awning motor
is damaged or
defective.
The awning does
The awning
not fully extend,
open limit is set
or extends too far
incorrectly.
(fabric edge sags).
6 Disposal
Place the packaging material in the appropriate
M
recycling waste bins, whenever possible. Consult
a local recycling center or specialist dealer for
details about how to dispose of the product in
accordance with all applicable national and local
regulations.
LIMITED ONE-YEAR
WARRANTY
LIMITED ONE-YEAR WARRANTY AVAILABLE AT
DOMETIC.COM/EN-US/TERMS-AND-CONDITIONS-
CONSUMER/WARRANTY.
IF YOU HAVE QUESTIONS, OR TO OBTAIN A COPY
OF THE LIMITED WARRANTY FREE OF CHARGE,
CONTACT:
DOMETIC CORPORATION
CUSTOMER SUPPORT CENTER
5155 VERDANT DRIVE
ELKHART, INDIANA 46516
1-800-544-4881
Power Case/Cassette Awning
Recommended
Solution
Check all the power
connections.
Reset the breaker,
or replace the fuse
as necessary. If
the issue persists,
contact a qualified
service technician.
Turn the power line
switch ON, or the
ignition disconnect
switch OFF.
Recharge the RV
battery.
Close the awning
manually and
contact a qualified
service technician.
See "Adjusting the
Open and Close
Limits" on page 6
to reset the limit.
EN
Advertisement
Table of Contents
