Procedure After Replacing The Microprocessor, Etc - Denon AVR-S510BT Service Manual

PROCEDURE AFTER REPLACING THE MICROPROCESSOR, ETC

The procedure after replacing the u-COM (Microprocessor), flash ROM, etc. is as follows.
PCB Name Ref. No.
Digital IC711 STM32F101ZG
Digital
IC722 MX25L3206EM2I-12G
Digital
IC742 MX25L8006EM2I-12G
Procedure after Replacement
A : The software has been written. The software is not written at the time of replacement.
B : The software has been written. The software may need to be rewritten by version updates. Check the version.
C : The software has not been written. The software needs to be written after replacement.
See "Firmware Update Procedure" for information on writing the software.
D : The software has been written. Be sure to rewrite with the latest software for your service region.
See "Firmware Update Procedure" for information on writing the software.
Description
Procedure
after
Replacement
B
SOFTWARE: Main
B
SOFTWARE: GUI ROM
B
SOFTWARE: DSP ROM
27
Remark