Technical Specifications - Metabo Of E 1229 Signal Original Instructions Manual

recycling of disused tools, packaging and
accessories.
Only for EU countries: never dispose of
power tools in your household waste!
According to European Directive 2012/19/EU
on Waste from Electric and Electronic Equipment
and implementation in national law, used power
tools must be collected separately and recycled in
an environmentally-friendly manner.

13. Technical Specifications

Explanatory notes on the specifications on page 3.
Changes due to technological progress reserved.
P = Rated input
1
P = Power output
2
n = Idle speed
0
n = Speed at rated load
1
H = max. stroke height
max
d = collet bore of the collet chuck
D = max. permissible diameter of the cutter
max
m = Weight without mains cable
Measured values determined in conformity with EN
62841.
High-energy, high-frequency interference can
cause speed fluctuations of up to 20%,
which subside when the interference disappears.
Machine in protection class II
~
AC Power
The technical specifications quoted are subject to
tolerances (in compliance with relevant valid
standards).
Emission values
These values make it possible to assess the
emissions from the power tool and to compare
different power tools. The actual load may be higher
or lower depending on operating conditions, the
condition of the power tool or the accessories used.
Please allow for breaks and periods when the load
is lower for assessment purposes. Arrange
protective measures for the user, such as
organisational measures based on the adjusted
estimates.
Vibration total value (vector sum of three directions)
determined in accordance with EN 62841:
a = vibration emission value
h
(Slot milling in MDF)
K = uncertainty (vibration)
h
Typical A-effective perceived sound levels:
L = sound pressure level
pA
L = acoustic power level
WA
K , K = Uncertainty
pA WA
The noise level can exceed 80 dB(A) during
operation.
Wear ear protectors!
ENGLISH en
15