Tips And Tricks; Troubleshooting; Accessories; Repairs - Metabo MHE 96 Operating Instructions Manual

9 Tips and Tricks

Only moderate pressure is required when working
with the machine. Applying excessive pressure
does not increase your working performance and
may decrease the service life of your machine.
KHE 96: in the case of deep bores, pull the drill bit
out of the bore from time to time in order to remove
dust.

10 Troubleshooting

Carbon brush service indicator (11) lights up:
the carbon brushes are almost completely worn
(remaining operating time approx. 30 hours). If the
brushes are completely worn, the machine
switches off automatically. Have an authorised
service centre replace the brushes.
Electromagnetic disturbance:
In individual cases, the speed may fluctuate
temporarily if the machine is exposed to extreme
external electromagnetic disturbances.

11 Accessories

Use only genuine Metabo accessories.
If you need any accessories, check with your
dealer.
For dealers to select the correct accessory, they
need to know the exact model designation of your
power tool.
See page 4.
A Extensive drill bit and chisel assortment for a
wide range of applications.
B Special grease (for lubricating the tool shanks)
For a complete range of accessories, see
www.metabo.com or the main catalogue.

12 Repairs

Repairs to electrical tools must be carried out by
qualified electricians ONLY!
Any Metabo power tool in need of repair can be
sent to one of the addresses listed in the spare
parts list.
Please enclose a description of the fault with the
power tool.

13 Environmental Protection

Metabo's packaging can be 100% recycled.
Scrap power tools and accessories contain large
amounts of valuable resources and plastics that
can be recycled.
These instructions are printed on chlorine-free
bleached paper.

14 Technical Specifications

Explanatory notes on the specifications on page 2.
Changes due to technological progress reserved.
P = Nominal power input
1
P = Power output
2
T = Torque
n = No-load speed
0
D = Max. drilling diameter in concrete
1
with impact masonry bits
D = Max. drilling diameter in concrete
2
with impact core cutters
D = Max. drilling diameter in concrete
3
with milling cutters
s = Maximum impact rate
max
W = Single impact force
C = Number of chisel positions
m = Weight without mains cable
During operation the noise level can exceed
85 dB(A).
Wear ear protectors!
The technical specifications quoted are subject to
tolerances (in compliance with the relevant valid
standards).
ENGLISH
ENG
9