Operations; Basic Operations - Clarion DB265MP Owner's Manual

8. OPERATIONS

Basic Operations

CAUTION
Be sure to lower the volume before switching
off the unit power or the ignition key. The unit
remembers its last volume setting. If you
switch the power off with the volume up,
when you switch the power back on, the
sudden loud volume may hurt your hearing
and damage the unit.
Turning on/off the power
Note:
• Be careful about using this unit for a long time
without running the engine. If you drain the car's
battery too far, you may not be able to start the
engine and this can reduce the service life of the
battery.
1. Press the [SRC] button.
2. The illumination and display on the unit light
up. The unit automatically remembers its last
operation mode and will automatically switch
to display that mode.
3. Press and hold the [SRC] button for 1
second or longer to turn off the power for the
unit.
Selecting a mode
1. Press the [SRC] button to change the
operation mode.
2. Each time you press the [SRC] button, the
operation mode changes in the following
order:
Radio mode ➜ CD/MP3 mode ➜ Radio
mode...
Note:
• If the CD/MP3 mode is selected when no disc is
inserted, the display shows "NO DISC".
Adjusting the volume
Turning the [ROTARY] knob clockwise
increases the volume; turning it
counterclockwise decreases the volume.
∗ The volume level is from 0 (minimum) to 33
(maximum).
10
DB265MP
Note:Be sure to read this chapter referring to the front diagrams of
chapter "2. CONTROLS" on page 3 (unfold).
Setting the Z-Enhancer
This unit are provided with 3 types of sound
tone effects stored in memory. Select the one
you prefer.
∗ The factory default setting is "Z-EHCR OFF".
Each time you press the [Z] button, the tone
effect changes in the following order:
Z-ENHANCER 1 ➜ Z-ENHANCER 2 ➜
Z-ENHANCER 3 ➜ Z-EHCR OFF ➜
Z-ENHANCER 1...
• Z-ENHANCER 1 : bass emphasized
• Z-ENHANCER 2 : treble emphasized
• Z-ENHANCER 3 : bass and treble emphasized
• Z-EHCR OFF
Audio mode adjustments
1. Press the [A-M] button to select the
adjustment mode. The mode switches as
follows each time the [A-M] button is
pressed:
BASS ➜ TREB ➜ BAL ➜ FAD ➜ Previous
mode
∗ When the Z-Enhancer function is turned on,
BASS (Bass) and TREB (Treble) cannot be
selected.
2. Turning the [ROTARY] knob to adjust the
selected audio mode.
BASS (Bass) : Adjustment range: –7 to +7
TREB (Treble) : Adjustment range: –7 to +7
BAL (Balance) : Adjustment range: L13 to R
FAD (Fader) : Adjustment range: F12 to
3. When the adjustment is complete, press the
[A-M] button several times until the function
mode is reached.
Note:
• During audio adjustment mode, if no operation is
performed for more than 7 seconds, this mode
can be cancelled and return to previous mode.
: no sound effect
13
R12