Fcc Information; How To Move The Treadmill - NordicTrack COMMERCIAL X22i User Manual

FCC INFORMATION

This console has been tested and found to comply with the limits for a Class B digital device, pursuant to part
15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference
in a residential installation. This equipment generates, uses, and can radiate radio frequency energy and, if not
installed and used in accordance with the instructions, may cause harmful interference to radio communications.
However, there is no guarantee that interference will not occur in a particular installation. If this equipment does
cause harmful interference to radio or television reception, which can be determined by turning the equipment off
and on, try to correct the interference by one or more of the following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and the receiver.
• Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
• Consult the dealer or an experienced radio/TV technician for help.
FCC CAUTION: To assure continued compliance, use only shielded interface cables when connecting to
computer or peripheral devices. Changes or modifications not expressly approved by the party respon-
sible for compliance could void the user's authority to operate this equipment.
IMPORTANT: To satisfy exposure compliance requirements, the antenna and transmitter in the console
must be at least 8 in. (20 cm) from all persons and must not be near or connected to any other antenna or
transmitter.
Note: The console contains FCC ID: OMC415325.

HOW TO MOVE THE TREADMILL

IMPORTANT: Due to the size and weight of the
treadmill, moving it requires two or three persons.
To avoid damaging the feet, do not move the tread-
mill by sliding it. Take any necessary measures to
protect your floor.
Before moving the treadmill, make sure the incline
level is at 0% (see page 23). Next, remove the key
and unplug the power cord.
Grasp the end of the frame on each side at the location
shown (A). CAUTION: To decrease the possibility
of injury or of damage to the treadmill, do not lift
the treadmill by the handrail. Raise the frame until
the treadmill will roll on the wheels (B). Then, carefully
roll the treadmill to the desired location and lower it to
A
the level position. CAUTION: To reduce the risk of
injury, use extreme caution while moving the tread-
B
mill. Do not attempt to move the treadmill over
uneven surfaces.
31