Speaker Placement; Switch On For The First Time, Special On Screen Message - Insignia IS-HTIB102732 User Manual

5 disc dvd/cd/mp3 dvd receiver
Table of Contents

Advertisement

Speaker Placement

The placement of speakers is very an important in the reproduction of surround sound. Particular attention
should be taken when designing the speaker layout. For the best surround effects, all speakers should be
installed.
A typical room layout should have the front left, front right and center placed along the front. The surround left
and surround right along the side towards the rear. The suround back speaker should be placed behind the
listener as shown in the above left picture. The center speaker can be placed above or below the video screen
or TV. The subwoofer can be installed for powerful bass sounds and can be placed anywhere in the room.
The speaker to listener dimensions shown in the above right picture is used for proper setup of the surround
system ( Please refer to Speaker Setup on P .16 ).
Note :
Do not connect more than one speaker to any pair of +/- speaker terminals.
Do not connect any speaker with an impedance lower than the speakers supplied.
Switch On for the First Time
Connect up the Home Theater System as shown in the preceding pages.
Connect Power to the Home Theater System.
The Home Theater System should have the Standby Light illuminated.
Press the Standby On / Off key (either on the front panel or the remote control).
Press DVD (either on the front panel or the remote control), it will change to DVD mode. After a few
seconds the panel will show "NO DISC".
Switch on your TV and select the AV input that the Home Theater System is connected to. You should
see the DVD Screen and a message "Insert a disc".
Press the open key (on the front panel or the remote control). The disc tray will open. Place a DVD disc
on the tray and press close key (same as open key). The player will read the disc and start playing.
Before the movie starts to play, a menu may be shown. You will need to high-light 'PLAY MOVIE' and
press [OK] to start playing the movie.
Although you can watch a movie immediately, you can configure a better performance on your Home
Theater System. You can press 'STOP' and proceed to do the system setup options on the next page.
This will set up all the functions on your Home Theater System. You only need to do this once when you
first install your Home Theater System.
If you choose to watch the movie you can find out about DVD options and navigation of the DVD disc in the
section "Playing a DVD disc" and onward.
Special On Screen Message
This symbol, when displayed, indicate that the key you have pressed is not available at this time,
or that this action is not allowed by the disc at this time.
GB 12
Center Speaker
Subwoofer
Front
TV
speaker
( left )
VIEWING AREA
Rear speaker
Rear speaker
( right surround )
( left surround )
Surround back speaker
Front
Subwoofer
Front
speaker
speaker
( left )
( right )
DIM L
Rear speaker
( left surround )
DIM LS
Surround back speaker
Center Speaker
Front
speaker
TV
( right )
DIM C
DIM R
Rear speaker
( right surround )
DIM RS
DIM SB

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents