Multi-Car Operation; Adding A New Transmitter Into The System; Deleting Transmitters - Clarion UNGO CS105 Owner's Manual

Multi-Car Operation

If you want to control multiple systems by a single Remote Transmitter, an optional 3-Button
Remote Transmitter is available. The 3-Button Remote Transmitter gives you the convenience
of operating several vehicles from a single Remote Transmitter.
For more information about Multi-Car operation, see your Dealer.

Adding a New Transmitter into the System

The system has the ability to recognize up to 20 individual remote transmitters. If the vehicle is
used by multiple drivers, each can have their own Remote Transmitter.
To add a Remote Transmitter:
1. Turn on the ignition.
2. Press and hold the Override switch.
• The status LED will turn on red.
3. Within 5 seconds:
Continue holding the Override switch and Press Transmitter Button 1 for remote
locking with chirp confirmation.
Release the Override switch and Press Transmitter Button 1 for remote locking
without chirp confirmation.
• The status LED will flash once quickly to confirm that the new Remote Transmitter
has been added.
4. Turn off the ignition.
Deleting Transmitters (Adding a Remote Transmitter and Erasing All
Other Remote Transmitters From the System)
1. Turn on the ignition.
2. Press and hold the Override switch.
• The status LED will turn on red.
Continue to hold the Override switch.
• After 5 seconds, the status LED will flash 4 times, then turn on red again.
3. Within 5 seconds:
Continue holding the Override switch and Press Transmitter Button 1 for remote
locking with chirp confirmation.
Release the Override switch and Press Transmitter Button 1 for remote locking
without chirp confirmation.
• The status LED will flash once quickly to confirm that the new Remote Transmitter
has been added.
4. Turn off the ignition.
--- or ---
--- or ---
Owner's Manual - Page 3