Connections Rrrrrrrrrrrrrrrrrrrrrr - Panasonic KX-FMC230 Operating Instructions Manual

Connections!
1 Connect the telephone line cord.
2 Connect the power cord.
¡When the power is turned on for the first
time, the unit will print an information list
about the starter film.
Power outlet
(120 V, 60 Hz)
Power surge
(
protector
Single telephone line
(RJ11C)
Line surge
(
protector
Note:
¡When the telephone line cord and power cord are connected, the unit will start detecting the dialing mode.
¡Display:
CHECKING LINE
¡Wait until one of the following messages is displayed.
¡—If your line has touch tone service,
LINE IS TONE
¡—If your line has rotary pulse dial service,
LINE IS PULSE
¡If the power cord is disconnected or a power failure occurs, the unit will detect the dialing mode again when
power is restored.
¡You can change the dialing mode setting manually. See "Setting the dialing mode" on page 42.
¡If you connect the power cord before connecting the telephone line cord, the following messages will be
shown alternately.
Display: CONNECT TEL LINE
Connect the telephone line cord.
¡For additional equipment protection, we recommend the use of a surge protector. The following types are
available; TELESPIKE BLOK MODEL TSB (TRIPPE MFG. CO.), SPIKE BLOK MODEL SK6-0 (TRIPPE
MFG. CO.), SUPER MAX (PANAMAX) or MP1 (ITW LINX).
¡When you operate this product, the power outlet should be near the product and easily accessible.
¡If the following message is displayed when the unit is plugged in, the recording paper set lever is released.
Display: CHECK LEVER
Move the lever back (see step 3 on page 20).
Power socket
Power cord
)
Telephone line cord
)
TEL LINE IS OPEN
Setup (Main Unit)
Connect to
"LINE".
LINE
21