Basic Operation; M Turning The Transceiver On Or Off; M Receiving And Transmitting - Icom IP501M Operating Manual

2

BASiC OpeRATiON

Basic operation
■ Turning the transceiver ON or OFF
Turning ON:
Hold down [DiAL] for 1 second to turn ON the transceiver.
• The standby screen is displayed as shown to the right.
L It may take a few minutes to boot up the transceiver for the fi rst time.
Turning OFF:
Hold down [DiAL] for 1 second to turn OFF the transceiver.
■ Receiving and Transmitting
Receiving:
When a Call is received, the [TX/RX] indicator lights green.
Rotate [DiAL] to adjust the audio output level to a comfortable listening level.
L When the volume is "0," key beeps and ringer tones do not sound.
Transmitting:
While holding down [pTT], speak at your normal voice level.
• The [TX/RX] indicator lights red while [pTT] is pushed.
Talk while receiving a call:
While receiving a call, push [pTT] to talk in the Full-Duplex mode* like a telephone call.
• in the Full-Duplex mode, the [TX/RX] indicator lights orange.
L Rotate [DiAL] to adjust the audio output level.
DO NOT cover the speaker or microphone.
* Depends on a presetting. Ask your dealer for details.
IMPORTANT:
To maximize the readability of your signal:
1. After pushing [pTT], pause briefly before you start speaking.
2. Hold the microphone 5 ~ 10 cm (2 ~ 4 inches) from your mouth, then speak at
your normal voice level.
About the Time-out Timer:
When the continuous transmission period exceeds 5 minutes, the Time-out Timer
automatically stops the transmission to prevent prolong transmissions. Release the
[pTT], then hold down again to resume talking.
2-2
ip501M
Ver. x.x.xx/x
Connecting...
00002
Setting up...
00002
10/14 12:00
All