I Programmed Scan - Icom IC-V8 Instruction Manual

I Programmed scan

Programmed scan repeatedly scans between two user pro-
grammed frequencies (memory channels "1A–3A" and "1b–3b") or
scans between upper and lower band edges. This scan is useful
for checking for signals within a specific frequency range such as
repeater output frequencies, etc. Scans between lower (start) and
high (stop) frequency.
q Push [D•
CLR
w Push [A•
FUNC
lected scan edge appears as "P1," "P2," "P3" or "AL."
• To change the scan edge, push [A•
times until the desired scan edge appears.
• "AL" for full scan, "P1", "P2" and "P3" for programmed scan be-
tween the programmed scan edge channels as "1A"–"1b,"
"2A"–"2b" and "3A"–"3b."
• To change the scan direction, push [Y] or [Z].
• When [VOL] is assigned as tuning dial, rotate [VOL] to change the
scan direction. (pgs. 17, 53)
e Push [D•
CLR
NOTE: Scan edges, 1A–3A/1b–3b, must be programmed in ad-
vance.
Program them in the same manner as regular memory chan-
nels. (p. 26)
If the same frequencies are programmed into the scan edges,
programmed scan will not proceed.
] to select VFO mode, if necessary.
], then push [5•
] to stop the scan.
SCAN OPERATION
] to start the scan, then a se-
SCAN
] then push [8•
FUNC
8
8
] several
SET
33