Extra Features; Instruction; Vfo Operation - Icom IC-78 Instruction Manual

Hf transceiver

Hide thumbs Also See for IC-78:

Table of Contents

EXTRA FEATURES

INTRODUCTION

Extra features, explained in this section, are available only on some versions of the IC-78. Therefore, the

instructions in this section are not necessary for some versions.

D Entering VFO mode

To enter VFO mode, push [FC] for 1 sec.

• VFO indicator appears.

• In the VFO mode, channel comment cannot be indi-

cated.

D Tuning

The transceiver has several ways of tuning for tem-

poral operation as follows;

• Tuning with the channel selector

By rotating the channel selector, operating fre-

quency changes in the desired tuning step, set in

the quick set mode . (p. 30)

This is the most convenient way when searching

for signals around the pre-programmed frequency.

• Tuning with the keypad

Enter the frequency as follows.

•Start

•To set to 25.118 MHz

•To set to 706 KHz (0.706 MHz)

•To set to 5.0000 MHz

•To change 13.1430 MHz to 13.3190 MHz

For duplex operation setting, push [TXF] then set

the transmit frequency, after the receive frequency

is set.

[FC]

Appears only when 1 Hz

tuning step is selected.

Changing digit; according to selected tuning step

Table of Contents