Data Cloning Between Transceivers - Icom IC-78 Instruction Manual

9
CONTROL COMMAND
• Command table
Command Sub command
00
01
02
03
04
05
06
08
0E
11
14
15
16
19

Data cloning between transceivers

• Data cloning
The IC-78's data (programmed frequencies, channel comment, both quick and initial set mode conditions, etc.) can
be copied to the other IC-78. This function is useful when exactly the same setting of the IC-78s is required.
• Cloning operation
q Turn power OFF.
w Connects a mini-plug cable between two IC-78's
(master and sub) [REMOTE] jack.
to [REMOTE]
e While pushing [TXF] and [FC], turn the master IC-
78 power ON.
r While pushing [SET] and [FC], turn the sub IC-78
power ON.
42
Description
— Send frequency data
— Send mode data
— Read Upper/Lower frequencies
— Read frequencies
— Read operating mode
— Set operating frequency
— Set mode
— Set memory
— Set memory channel
00 Scan stop
01 Memory scan start
— ATT
01 AF gain
02 RF gain
03 Squelch level
01 Read squelch Open/Close
02 Read S-meter level
02 PREAMP
22 Noise blanker
44 Microphone compressor
00 Read ID
[REMOTE] jack
Mini-plug cable
to other IC-78's
[REMOTE]
Master transceiver
indicates "M".
t Push [TONE] of the master IC-78 to start cloning.
Daughter transceiver
indication
• After cloning complete;
y Turn power OFF
Master transceiver
indication
Daughter transceiver
indication