Model Id Setting - Fisher & Paykel CleanSmart WL8060P1 Service Diagnostic Manual

Model ID setting

With the shift to common motor control modules across multiple models (global controller) it will be
necessary when changing the controller to pair the controller to the display module. This process is
called 'Model ID setting'.
To set the Model ID
Turn the 'Power' on at the supply and off at the console
Press 'Keylock' and 'Spin Speed' until the machine beeps
Select the correct model as per the table below using the '+' key' to toggle through the options
Press the 'Start/Pause' button; the LED's are illuminated to confirm the selection.
Incompatible
electronic
combination
WL8060P1
WA8560P1
WA8060P1
WA1060E1
WA1060E2
WA8560E1
WA8060E1
WA7560E1
WA7060E1
WA1060G1
WA8560G1
WA8060G1
If A 00 shows in the display check the part numbers of the controller and or display being fitted
as they are not compatible with each other
6
A 00
A 01
A 02
A O3
A 04
A 05
WA7060G1
WA7060M1
WA9060G1
WA7060G2
WA7060M2
A 06
A 07
A 09
A 09
A 10