Table of Contents
Advertisement
Installation test
Correct installation of the washer is very important to the performance of the machine especially the
dynamics of the spin cycle. To aid with the installation an install procedure is attached on the top of
the lid of each machine. As part of this procedure there is an installation test routine that checks the
water inlet hot & cold, drain and low speed spin of the machine. The test routine takes approximately 3.5
minutes to complete. This proceedure may also be helpful when used after completing a repair to the
machine.
Check the installation and operation of the washer using the following procedure:
Touch 'Power' to activate your washer.
Touch both 'Keylock' and 'Options' buttons at the same time, and hold for three seconds.
Touch 'Start/Pause' and the display will show
and the lid will lock.
The washer will beep to signal the end of the installation test cycle. If there are no faults found, the
washer will automatically turn off at the end of the installation test cycle. Any faults will be displayed on
the screen (refer to the back of this user guide to help identify faults).
Note: if there are no faults found, the washer will automatically turn off at the end of the installation test
cycle.
7
Hide quick links:
Advertisement
Table of Contents
