Notice For This Monitor - Eizo Radiforce GX550 Instructions For Use Manual

Notice for this monitor

Intended use
This product is intended to be used in displaying and viewing digital images, including standard and
multi-frame digital mammography, for review, analysis and diagnosis by trained medical practitioners.
It is specially designed for breast tomosynthesis applications.
Caution: Federal law (USA) restricts this device to sale by or on the order of a physician.
Attention
• This product may not be covered by warranty for uses other than those described in this manual.
• The specifications noted in this manual are only applicable when the following are used:
- Power cords provided with the product
- Signal cables specified by us
• Only use optional products manufactured or specified by us with this product.
Installation Requirements
• Carefully read the "PRECAUTIONS" (page 3) and always follow the instructions.
• When installing the monitor in a rack, ensure that there is adequate space around the sides, back
and top of the monitor.
• Position the monitor so that there is no light to interfere with the screen.
• If you place this product on a lacquer-coated desk, the color may adhere to the bottom of
the stand due to the composition of the rubber. Check the desk surface before use.
Maintenance
• The display quality of monitors is affected by the quality level of input signals and the degradation of
the product. It is recommended that daily checkups and periodical constancy test be performed to
comply with medical standards/guidelines according to your application. Use of the RadiCS monitor
quality control software enables you to perform high-level total quality control that meets medical
standards/guidelines.
• It takes about 15 minutes for the performance of electrical parts to stabilize. Please wait 15 minutes
or more after the monitor power has been turned on or the monitor has recovered from the power
saving mode, and then adjust the monitor.
• It takes about a few minutes for the image quality to reach acceptable level. Please wait a few
minutes or more after the monitor power has been turned on or the monitor has recovered from the
power saving mode, and then view images for diagnosis.
• Monitors should be set to a lower brightness to reduce changes in luminosity caused by long-term
use and maintain a stable display. Periodically perform constancy tests. Calibrate if necessary. For
details, refer to the User Manuals for the RadiCS/RadiCS LE monitor quality control software.
• To maintain the measurement accuracy of the integrated front sensor, perform periodical correlation
using RadiCS/RadiCS LE.
• Parts (such as the LCD panel) may deteriorate over the long term. Periodically check that they are
operating normally.
7
Notice for this monitor