Fisher & Paykel Classic Series Installation Manual page 4

IMPORTANT SAFETY INSTRUCTIONS!
A risk of the appliance tipping over exists if the appliance is not installed in accordance
● ●
with installation instructions.
Check local building codes for the proper method of range installation. Local codes vary.
● ●
Installation, electrical connections, and grounding must comply with all applicable codes.
● ●
In the absence of local codes, the range should be installed in accordance with the latest
● ●
edition of National Electrical Code ANSI/NFPA 70.
● ●
In Canada: Electrical installation must be in accordance with the current CSA C22.1
● ●
Canadian Electrical Codes Part 1 and/or local codes.
Some models are supplied with a protective film on steel and aluminum parts. This film
● ●
must be removed before installing/using the appliance.
Packing elements (eg plastic bags, polystyrene foam, staples, packing straps etc) and
● ●
tools should not be left around during and after installation, especially if they are within
easy reach of children, as these may cause serious injuries.
Make sure you recycle the packaging material.
● ●
Before disposing of any appliance, make sure that it can no longer be used and that all
● ●
hazardous parts are removed or made harmless, so that children playing with the old
appliance cannot harm themselves.
IMPORTANT!
SAVE THESE INSTRUCTIONS
The models shown in this installation guide may not be available in all markets and are subject to change at any time. For current details about model and specification availability in your country,
please go to our website fisherpaykel.com or contact your local Fisher & Paykel dealer.
4
SAFETY AND WARNINGS
GENERAL INSTALLATION INFORMATION
Cleaning and servicing
Service should only be performed by an authorized technician.
● ●
Disconnect the electrical supply to the appliance before servicing.
● ●
When removing appliance for cleaning and/or service:
● ●
Disconnect AC power supply.
● ●
Carefully remove the range by pulling outward.
● ●
The misuse of oven door (eg stepping, sitting, or leaning on them) can result
● ●
in potential hazards and/or injuries.
When installing or removing the range for service, a rolling lift jack should be used.
● ●
Do not push against any of the edges of the range in an attempt to slide it into or
out of the installation. Pushing or pulling a range (rather than using a lift jack) also
increases the possibility of bending the leg spindles or the internal coupling connectors.
IMPORTANT!
Range is heavy; use care in handling.
● ●
Do not lift the range by the oven door handle or hob rail, or by lifting the cooktop trim as
● ●
this may damage the appliance.
Replacement parts
Only authorized replacement parts may be used in performing service on the range.
Replacement parts are available from factory authorized parts distributors.
Contact the nearest parts distributor in your area.