Fitting The Adjustable Feet - Fisher & Paykel Classic Series Installation Manual

Fitting the adjustable feet

The adjustable feet must be fitted to the base of the range before use.
Rest the rear of the range on a piece of the polystyrene packaging exposing
the base for the fitting of the feet.
IMPORTANT
Take care not to damage the range during this operation.
Fit the four legs by screwing them tight into the support base as shown.
Levelling the range
The range may be levelled by screwing the lower ends of the feet IN or OUT.
● ●
Small adjustments may be made to the range in the upright position, however it
● ●
may be necessary to tip the range again to make larger adjustments.
FITTING THE ADJUSTABLE FEET
Fitting the adjustable feet covers (optional)
If using the adjustable feet covers fit these while the range is tipped over.
Tip range onto its back to expose
1
foot cover mounting hole locations.
Note: gently bend the edges of the
3
inner cover to adjust the tension
between the two parts if needed.
Stand range back upright.
5
Assemble the feet covers by slotting
2
the inner cover inside the outer
cover.
Attach the feet covers to the base of
4
the range using the supplied screws.
Ensure that the mounting brackets
are aligned with the mounting holes
in the base of the range.
Adjust the inner panels of the foot
6
covers to suit the height of the
range feet as necessary.
11