Table of Contents
Advertisement
Now you will see the LED for Port 1 light up, and you will hear a beep. Switch on your monitor.
N
:
OTICE
Please be remind to plug in power adapter. Although the PCs connected to BHK-117-16e are
able to support enough power to the stand alone switch, BHK-117-16e still needs a power
adapter for daisy chain more banks. If you forget to plug in power adapter on the status of
daisy chain, it may cause the unexpected status occurred.
Usage
The power on state of BHK-117-16e :
When you power on BHK-117-16e, it will ask you the password, the default password value
is eight zero –" 00000000 ". Please key in eight zero and enter the same value at retype field.
Note: Before you are not familiar with the operation of OSD menu, please don't change the
password – i.e. keep default eight zero (00000000) value. Otherwise, if you have set the
password and unfortunately forget the password, you need send it back to your distributor for
maintaining the password.
1
2
3
4
5
6
7
8
16
15
14
13
12
11
10
9
7-Segment LED Indication:
You can press the button in order like mentioned-above diagram.
When you select one of sixteen PC ports and this PC is powered on, the selected port LED is lit.
When you select one of sixteen PC ports and this PC is shut down or disconnected a PC, the
selected port LED will flash.
Reset Button (
(Bank Select) and
(Port Select) ):
To press both "select" button and "bank" button of master bank simultaneously can reset
BHK-117-16e. This reset action will not only return BHK-117-16e back to initial state --- Check
the password, but also re-check all of slave banks which connected to mast BHK-117-16e.
If you add a new BHK-117-16e as a slave bank, please use reset button of master
BHK-117-16e to automatically assign a new ID to it. You can view this new slave bank go
through OSD menu. The PC ports of BHK-117-16e does not be reset by reset command.
Keyboard Hot Key Commands:
You can also conveniently command BHK-117-16e by switching ports through simple key
sequences. To send commands to BHK-117-16e, the "SCROLL LOCK" key must be
pressed twice within 2 seconds. You will hear a beep for confirmation and the keyboard is in
hot key mode. If you have not pressed any key in hot key mode within 2 seconds (It means to
key in any key follows up "Scroll Lock" "Scroll Lock" key ), the keyboard will back to under
BHK Series Manual
www.i-techcompany.com
32
Advertisement
Table of Contents
Troubleshooting
