Partition For Paper Roll; Setting Dip Switch - Citizen CT-S4000 User Manual

3.5 Partition for Paper Roll

At the time of shipment, this partition is not installed.
1. Confirm that the power switch is OFF.
2. Open the printer cover.
3. Insert the partition into the slot and align it
with the scale inside of the printer which
meets the width of the paper roll used. When
using the 80mm or 82.5mm wide paper roll,
set the partition by using the accessory screw.
4. Change the setting of paper width by reffering
to the section 5.2, "Manual Setting of Memory
Switch".
CAUTION!
When using 112 paper roll, the partition is not used.

3.6 Setting DIP Switch

The DIP switch is present on the serial
interface board.
The function of each switch is as shown
below.
CAUTION!
■ As for the setting of the serial interface, it gives priority to the setting of the memory
switch rather than the DIP switch as the factory default.
■ Consult with the dealer where the printer was purchased when the change of the DIP
switch setting is necessary.
Switch No. Function
1 Communication condition DIP switch setting
setting method
2 Hand shake
3 Bit length
4 Parity check
5 Parity selection
6
Baud rate selection
7
8 INIT
Selecting baud rate
Baud Rate (bps)
2400
4800
9600
19200
38400, 57600 and 115200 bps can also be selected by a command, etc.
Interface board
mounting screws
ON
XON/XOFF
7 bits
With parity
Even parity
See Table below.
Reset
Switch No.
6
OFF
ON
OFF
ON
— 15 —
Partition
→
Scales
→
80mm 82.5mm
InitialSettings
OFF
Memory switch
setting
DTR/DSR
8 bits
None
Odd parity
Invalid
7
OFF
OFF
ON
ON
Partition
DIP switch
OFF
OFF
OFF
OFF
OFF
OFF
ON
OFF