Rear Wheel - Yamaha XT250N 2000 Owner's Manual

w
Always use a new cotter pin for the
axle nut.
Tightening torque:
Axle nut:
85 Nm (8.5 m0kg)
6. Connect the speedometer cable,
and then install the speedometer
cable holder by installing the
screw.
7. Install the brake disk cover by
installing the screws.
w
Always use a new cotter pin for the
axle nut.
8. Install the engine guard by
installing the bolt.
PERIODIC MAINTENANCE AND MINOR REPAIR
EW000110
1. Engine guard
2. Bolt

Rear wheel

To remove the rear wheel
w
8 It is advisable to have a
EW000110
Yamaha dealer service the
wheel.
8 Securely support the motorcy-
cle so that there is no danger
of it falling over.
1. Remove the engine guard by
removing the bolt.
2
1
1. Brake pedal free play adjusting nut
2. Brake rod
3. Brake camshaft lever
EAU03698
4. Cotter pin
5. Chain adjusting plate
6. Axle nut
EW000122
6-38
a
3
1
5
2. Remove the brake pedal free
play adjusting nut, and then dis-
connect the brake rod from the
brake camshaft lever.
3. Remove the cotter pin, and then
loosen the axle nut.
4. Turn the drive chain adjusting
plate on each side of the
swingarm fully in direction a.
5. Lift the rear wheel off the ground
according to the procedure on
page 6-35.
6. Remove the axle nut.
1
6
4
2
2
3
4
5
6
7
8
9