Lubricating The Drive Chain; Checking And Lubricating The Cables - Yamaha XT250N 2000 Owner's Manual

Lubricating the drive chain

The drive chain must be cleaned and
lubricated at the intervals specified in
the periodic maintenance and lubrica-
tion chart, otherwise it will quickly
wear out, especially when riding in
dusty or wet areas. Service the drive
chain as follows.
cC
The drive chain must be lubricated
after washing the motorcycle or
riding in the rain.
1. Clean the drive
kerosene and a small soft brush.
cC
To prevent damaging the O-rings,
do not clean the drive chain with
steam cleaners, high-pressure
washers or inappropriate solvents.
2. Wipe the drive chain dry.
PERIODIC MAINTENANCE AND MINOR REPAIR
EAU03006
3. Thoroughly lubricate the drive
chain with a special O-ring chain
lubricant.
cC
Do not use engine oil or any other
lubricants for the drive chain, as
they may contain substances that
could damage the O-rings.
EC000097
chain with
ECA00053
Checking and lubricating the
cables
The operation of all control cables
ECA00052
and the condition of the cables
should be checked before each ride,
and the cables and cable ends
should be lubricated if necessary. If
a cable is damaged or does not move
smoothly, have a Yamaha dealer
check or replace it.
w
Damage to the outer sheath may
interfere with proper cable opera-
tion and will cause the inner cable
to rust. Replace a damaged cable
as soon as possible to prevent
unsafe conditions.
6-26
Recommended lubricant:
Engine oil
EAU02962
1
2
3
4
5
6
EW000112
7
8
9