Yamaha XT250N 2000 Owner's Manual page 50

2
1. Oil filter element
2. O-ring (×2)
8. Remove the oil filter element and
O-rings.
9. Check the O-rings for damage
and replace them if necessary.
10. Clean the oil filter element with
solvent, and then install it.
NOTE:
Check the oil filter element for dam-
age and replace it if necessary.
11. Install the oil filter element cover
by installing the screws and drain
bolt, then tightening them to the
specified torques.
PERIODIC MAINTENANCE AND MINOR REPAIR
Tightening torques:
1
Oil filter element cover screw:
7 Nm (0.7 m.kg)
Oil filter element drain bolt:
10 Nm (1.0 m.kg)
NOTE:
Make sure that the O-ring is properly
seated.
12. Install the engine oil strainer,
compression spring, O-ring and
engine oil drain bolt, and then
tighten the drain bolt to the spec-
ified torque.
cC
Before reinstalling the oil drain
plug, do not forget to install the O-
ring, compression spring, and oil
strainer in position.
Tightening torque:
Engine oil drain bolt:
43 Nm (4.3 m0kg)
13. Add the specified amount of the
EC000071
cC
6-10
recommended engine oil, and
then install and tighten the oil
filler cap.
Recommended oil:
See page 8-1.
Oil quantity:
Without oil filter element
removal:
1.0 L
With oil filter element removal:
1.1 L
Total amount (dry engine):
1.3 L
8 In order to prevent clutch slip-
page (since the engine oil also
lubricates the clutch), do not
mix any chemical additives
with the oil.
8 Make sure that no foreign
material enters the crankcase.
1
2
3
4
5
6
7
EC000066
8
9