Hussmann DSF Installation And Operation Manual page 16

Hang glass on lower hardware
1. Hang glass on lower hardware. Please note the glass must be
verticle in order for the rod to slide into the hardware.
(See diagram)
Attach piston to glass
1. Open door and slide piston over to where
the lower hardware is located.
2. Slide piston over the inside
theball nut. (pictured)
3. Insert pin into hole and hook the "C"
shaped part of the pin over
the shaft of the piston.
Tighten down uper (piston) hardware
1. Compress piston 3/8"
2. Tighten down upper hardware with a
3mm Allen Wrench.
Illustration 4
16
IGSV-DSF, DSFM-0303
Snap rounded
portion of pin
around piston
Hole for pin