Hussmann DSF Installation And Operation Manual page 14

LUSTRATION ON THE NEXT PAGE.
GLASS ADJUSTMENT – LEFT/RIGHT
1. Open glass panel
2. Loosen hinge set screws (1)
3. Slide glass panel to left or right carefully
4. Retighten screws
GLASS ADJUSTMENT – TOP EDGE ALIGNMENT
1. Pull glass bumper out of channel.
2. Adjust screws attached to bumper.
3. Replace the bumper in the same orientation as it was removed.
4. Repeat as necessary.
Piston
Hinge mounting/adjusting screws
DSF, DSFM Glass Installation
Install Clamshell onto Glass
HARDWARE
1. Slip rubber channel over straight edge of glass being
inserted into clamshell
2. Insert aluminum wedge shaped rod into clamshell.
3. Insert glass as pictured in Illustration 1.
4. Tighten down set screws along the clamshell using |
a 2mm Allen Wrench.
Glass bumper depth adjustment screw
Glass bumper (shown pulled from channel)
Illustration 1
14
IGSV-DSF, DSFM-0303
Aluminum Wedge
Rubber Gasket