Pg Compucall X.25 Link Configuration; Peripheral Monitor Configuration Of Acd Positions; Table 5: Compucall Link Parameters - Cisco NORTEL SL-100 Supplement Manual

If you configure the PG to connect at SCAI-11F
SCAI level set on the DMS100 switch, the PG will function with the
switch.
There is no specific configuration required on the DMS100 switch to
ensure that PG connects with a lower SCAI level set at the PG. The
DMS100 switch handles the configuration transparently and auto-
negotiates the SCAI version (ServiceVersion) with the PG.

2.8. PG CompuCALL X.25 Link Configuration

This section describes how the PG must be configured through the Setup
program to talk to the CompuCALL X.25 Link.

Table 5: CompuCALL Link Parameters

X.25 Link Parameter
X25 Port
X25 User Data
X25 Local Address
X25 Remote Address

2.9. Peripheral Monitor Configuration of ACD Positions

To be able to monitor the CompuCALL event messages, you must
configure all of your Primary ACD or Secondary DN positions in the
peripheral monitor table. The DMS-100 Peripheral Gateway will perform a
DV_DN_ASSOCIATION for each of the Primary ACD DNs configured
in the Peripheral Monitor TableF
Primary ACD DN to be associated with the current session, the DMS-100
1
The PG continues to support SCAI-11 and no new features that are part of SCAI
versions higher than SCAI-11 are supported by the PG.
2
All the devices associated in the call need to be monitored by the DMS100 PG,
in order to avoid any missing events being missed from the DMS100 to the
system. These events could impact system functionalities like call routing,
reporting etc.
Peripheral Monitor Configuration of ACD Positions
Example
1
0 0 0 0
02402027
00000555
2
F. If the DMS-100 PG specifies a
21
1
F, irrespective of the
Description
Integer identifier for the X25
card install on the local
computer
Four octets of data (each octet
ranging from 0 to 255,
expressed in hexadecimal).
These data are provided by the
Interexchange Carrier as the
PROTOCOL subfield. Each
octet is separated by a white
space
Is X.25 DTE address of the
local computer provided by
the system administrator
X.25 DTE address of the
remote switch provided by the
system administrator
21
21