Introduction; Inspection; Location; Skid - Hussmann HGL-1BS Installation And Service Instructions Manual

INTRODUCTION –
Hussmann HGL B/T models are
remote, low temperature, vertical display
merchandisers for ice cream and frozen
foods. Design features include heated
glass doors for fog free visibility, auto-
matic defrost, and efficient foamed in
place non-CFC insulation. These models
are designed for remote installation as
single cases or multiplexed with other
cases.
INSPECTION –
Upon receipt of the cabinet, care-
fully examine the crating for damage. If
crate is damaged, make a note on the de-
livery ticket before signing. Carefully re-
move shipping crate and examine cabinet
for "concealed" damage. If damage is
found, contact the delivery carrier imme-
diately and have his agent prepare an in-
spection report for the purpose of filing a
claim. This is your responsibility.
LOCATION –
Avoid locating the cabinet where
direct sunlight would shine into the fix-
ture or where drafts from air condition-
ing grills, fans and open doors could af-
fect its operation.
INSTALLATION and START-UP –
SKID –
The skid should be left on the unit
until it is near its final location. The skid
provides protection for both case and
floor. The skid is removed by raising one
end of the case approximately six inches.
BLOCK SECURELY and remove
the two skid bolts on the raised end. The
procedure is repeated on the opposite end.
When the skid bolts are removed, the case
may be slid off the skid.
LEG INSTALLATION – Top Mounts
Only
After the case is near its final loca-
tion and the skid has been removed, the
NSF approved legs should be installed.
The legs are packaged inside the cabinet.
Replace the tape and door blocks. To in-
stall legs, raise one end of the cabinet ap-
proximately eight (8) inches, BLOCK SE-
CURELY, and install two legs. The leg
mounting plates are factory installed and
contain a 1/2 x 13 tapped hole to mate
with the leg assembly. The procedure is
repeated on the opposite end. The 3-door
requires legs in the center. With cabinet
legs installed, the cabinet should be posi-
tioned in its final location and leveled.
The cabinet is leveled by turning
the bottom section of each leg. The self-
closing doors require the cabinet to be
properly leveled. End to end leveling will
make the door (s) close with uniform
speed and tightness. A slight pitch from
front to rear is desirable. THE CABI-
NET BACK SHOULD NEVER BE
HIGHER THAN THE FRONT.
Page 5