Panasonic PV-DV101 Manual page 230

Transferring Your Images
Transferring Your Images
Using Tape Image Data
(PHOTOVU LINK/Movie
Messenger) (USB)
By connecting the Palmcorder and PC with
the USB Cable, you can transfer Motion
images and Still images saved on the DV
Tape directly to your PC.
2
PLAY Button
To capture Still images
3
Click on [STILL CAPTURE] at the point
you wish to capture an image.
• Repeat step 3
images.
• Captured Still images are saved to the
PC, and you can playback the saved
images on the Image Browser. (See
page 59.)
58
3
STILL
CAPTURE
3
MOVIE
CAPTURE
to continue capturing
Before you begin
• Insert a recorded tape. (See page 9.)
• Make Palmcorder-PC connections.
(See page 54.)
• Turn your PC on. (See page 54.)
• Set Palmcorder POWER to VCR.
1
Repeat steps 1~4 on page 57 to
run the PHOTOVU LINK/Movie
Messenger.
Note
• When the USB Cable is connected,
the input display will automatically
become USB. If it is not USB, please
confirm the connection. Then, close
and restart the software.
2
Click (PLAY) on PC screen to
playback the DV tape.
• The playback screen cannot be
viewed on the PC. Please use the
LCD monitor on the Palmcorder for
confirmation.
To capture Motion images
3
Click on [MOVIE CAPTURE] at the start
point you wish to capture a Motion
image.
4
Click [MOVIE CAPTURE] or [STOP] to
end capture.
• "Now Searching" is displayed.
• The DV Tape is rewound to the point
at which the capture was started. The
Motion image is then transferred to the
PC.
• "Data transfer is now in progress" is
displayed on the PC screen.
• The maximum capture time is approx.
30 seconds. Capture stops
automatically at the end of 30 seconds.
Note
• Motion images cannot be captured if data
contains the following...
• A change between 12 bit and 16 bit.
• A change between SP and LP mode.
• During transfer to the PC, the Motion
images will not be displayed on the PC
screen.
• Transfer takes from about 30 to 50
seconds for every 1 second of the Motion
image.
5
To capture other Motion images, repeat
steps 3~4.