Removal And Replacement Of Evaporator - Hoshizaki KML-200MAE Service Manual

7. REMOVAL AND REPLACEMENT OF EVAPORATOR

Always install a new Drier every time the sealed refrigeration system is
opened. Do not replace the Drier until after all other repairs or replacement
have been made.
1) Turn off the power supply.
2) Remove the panels and the Top Insulation over the Evaporator.
3) Recover the refrigerant and store it in an approved container.
4) Remove the Spray Tube and the Insulated Rubber Tube at the "U" shaped notch where
the refrigeration tubings go through the chassis.
5) Remove the Insulation Tube, and disconnect the Evaporator Inlet Tubing at the Tee next
to the Expansion Valve.
6) Lift up the Evaporator, and disconnect the Evaporator Outlet Tubing.
7) Install the new Evaporator.
8) Install the new Drier.
9) Check for leaks using nitrogen gas (140 PSIG) and soap bubbles.
10) Evacuate the system, and charge it with refrigerant. See the Nameplate for the required
refrigerant charge.
11) Replace the removed parts in the reverse order of which they were removed.
12) Replace the Top Insulation and the panels in their correct positions.
13) Turn on the power supply.
IMPORTANT
39