Stanley PNT1000L-PC Instruction Manual page 19

Installing the POP NUT™ into the work piece
1. With the POP NUT™ mounted on the Mandrel, insert it perpendicularly into the hole of the work piece
2. Pull the trigger and hold it to install the insert
3. Keep trigger depressed until the Mandrel reverses direction and completely unthreads the Mandrel from the insert.
4. Lightly pull the tool away from the work piece as Mandrel is reversing to disengage it from the insert.
5. Once the tool is disengaged from the insert, release the trigger.*
Note:
• Fit the fl ange of the insert fl at against the work piece.
• Do not tilt the tool. The tool must be perpendicular to the work piece.
Figure 11: Proper insertion of POP NUT™ threaded inserts into an application
Figure 9: Loading the POP NUT™ onto tool
Trigger
PULL
Work piece
Figure 10: Setting the POP NUT™
OK
OK
Gap
Not OK
LIGHTLY PULL
HOLD
Not OK
Gap
E N G L I S H
RELEASE
Not OK
19