Stanley PNT1000L-PC Instruction Manual page 25

11. After replacement of the hydraulic oil, line up the Air Piston Assembly and the Tube Insertion Hole in the Handle Lower
and push the Tube into place.
12. Pass the Tube into the tube insertion holes in the Air Piston Assembly and the Handle Lower
13. Replace the Chamber and the four (4) truss head machine screws and tighten
14. Place the tool on its side so that the Fill Screw is uppermost.
15. Use a fl at bladed screwdriver to unscrew the fi ll screw to let any excess oil and air (bubbles) escape.
16. Once the hydraulic oil stops coming out, tighten the Fill Screw
Air Piston
Assembly
Handle Lower
Figure 19: Recharging and purging air bubbles
Figure 20: Purging excess oil
Tube Insertion
Hole
Tube
Tube Insertion
Hole
E N G L I S H
Air Piston
Assembly
Tube
25