User Manual
GFK-2737L
Figure 8: Install Module into RX3i Backplane Backplane
3.3.5
Module Removal
•
•
•
•
•
Figure 9: Remove Module from RX3i Backplane
Installation
RX3i rack power must be turned off.
For revision -Axxx modules, loosen the heat sink screw on the front of the module
to release the heat sink from the backplane's aluminum back plate.
Loosen the screws at the bottom of the module (1).
Pivot the module upward until its connector is out of the backplane (2).
Lift the module up and away from the backplane to disengage the pivot hook (3).
Section 3
Jul 2022
35