Installation; Pre-Installation Check - Emerson PACSystems RX3i User Manual

User Manual
GFK-2737L
Section 3:
This chapter provides instructions for installing PACSystems RX3i PROFINET Controller
modules.
•
•
•
•
•
•
•
•
•
For additional information about system installation, also refer to the PACSystems RX3i
Systems Manual, GFK-2314.
3.1

Pre-Installation Check

Upon receiving your RX3i equipment, carefully inspect all shipping containers for damage.
If any part of the system is damaged, notify the carrier immediately. The damaged shipping
container should be saved as evidence for inspection by the carrier.
As the consignee, it is your responsibility to register a claim with the carrier for damage
incurred during shipment. However, Emerson will fully cooperate with you, should such
action be necessary.
After unpacking the RX3i equipment, record all serial numbers. Serial numbers are required
if you should need to contact Customer Care during the warranty period. All shipping
containers and all packing material should be saved should it be necessary to transport or
ship any part of the system.
Verify that all components of the system have been received and that they agree with your
order. If the system received does not agree with your order, contact Customer Care.
If you need technical help, contact Technical Support. For phone numbers and email
addresses, see the Contact page in the front of this manual.

Installation

Installation
Pre-Installation check
Power Requirements
Hot insertion and removal
Removing the backplane knockout
Module installation and removal
Port connections
Installing SFP devices
Installing the USB Port Driver
Firmware updates
Section 3
Jul 2022
31