Advertisement
7.
Connect hydraulic line to top end of hydrau-
lic ram cylinder and hydraulic tank (see
Figure 8).
8.
Attach pressure gauge to the top of hydraulic
ram (see Figure 8).
Note: Use thread tape on pressure gauge
threads to ensure a proper seal during opera-
tion.
Pressure
Gauge
Figure 8. Pressure gauge and hydraulic line
connected to hydraulic ram.
9.
Assemble bed with (4) sleeve spacers
between bed sides and secure together with
(4) M10-1.5 x 130 hex bolts, 10mm lock
washers, 10mm flat washers, and M10-1.5
hex nuts, as shown in Figure 9.
Press Bed
(1 of 2)
Sleeve Spacer
Figure 9. Assembling press bed.
-4-
Hydraulic
Line
Connected
x 4
(1 of 4)
10. Insert bed support rods through holes in
each column to support press bed at desired
height (see Figure 10). Lift bed into place
and rest it on support rods
ALWAYS make sure support rods are sup-
porting bed evenly! Failure to support press
bed evenly could lead to bed accidentally
dropping during setup or operation, which
may result in crushing injury.
11. Place table plates on press bed, and insert
pump handle into left or right receiver on top
of hydraulic tank (see Figure 10).
Note: Left receiver is used for smaller incre-
mental ram movement, and right receiver is
used for larger incremental ram movement.
Table
Plates
Bed Support
Rods
Figure 10. Table plates and handle positions.
T1241 20-Ton Hydraulic Press (Mfd. Since 7/20)
Pump
Handle
Left
Receiver
Right
Receiver
Advertisement
