Advertisement
This machine is very
heavy. Reduce risk of
strain or injury by getting
help when lifting.
3.
With help from an assistand, secure cross
beams to top of columns (see Figure 4) with
(8) M16-2 x 35 hex bolts, 16mm flat washers,
16mm lock washers, and M16-2 hex nuts.
When installing second cross beam, position
ram mounting plate over bottom edges of
cross beams, as shown in Step 4.
Cross
Beams
x 4
Columns
Figure 4. Securing cross beams to columns with
ram mounting plate positioned on bottom edge.
4.
Secure ram mounting plate in center of cross
beams using (4) M8-1.25 x 16 hex bolts
through pre-drilled holes in mounting holes
(see Figure 5).
x 4
Figure 5. Securing ram mounting plate to cross
beams.
T1241 20-Ton Hydraulic Press (Mfd. Since 7/20)
Ram Mounting Plate
5.
From above, insert hydraulic ram cylinder
through hole in ram mounting plate and
thread ram collar into position, as shown in
Figure 6.
Note: Ram collar can be tightened by insert-
ing a Phillips head screwdriver into collar
holes and lightly tapping across shaft of
screwdriver with a mallet to rotate until tight.
Collar
Hole
Hydraulic
Ram
Cylinder
Figure 6. Securing hydraulic ram to mounting
plate with ram collar.
6.
Attach hydraulic reservoir assembly to right
side of press column (see Figure 7) with (2)
M10-1.5 x 25 hex bolts, 10mm flat washers,
and 10mm lock washers, and M10-1.5 hex
nuts.
Hydraulic
Reservoir
Assembly
Frame
Mounting
Bracket
Figure 7. Mounting hydraulic reservoir assembly.
Ram
Collar
x 4
-3-
Advertisement
