3Com EtherLink 3CR990-TX-95 User Manual page 37

WARNING: Make sure that the PC power cord is
unplugged. Only properly trained and authorized
personnel should perform service. Contact your PC
manufacturer for information about safe service
techniques.
To connect the Remote Wake-Up cable:
1 Make sure that the NIC is properly installed in a PCI slot.
2 Insert the Remote Wake-Up cable into the
RWU connector on the NIC.
Twist the cable twice before attaching the cable to the PC.
3 Attach the other end of the cable to the connector on
the PC motherboard.
Refer to your PC documentation if you need help locating
the connector.
4 Replace the PC cover and plug in the power cord.
Do not turn on the power to the PC. Continue at step 3 in
Installing and Connecting the NIC.
Connecting the Remote Wake-Up Cable 37