Configuring Midi Devices 配置Midi装置; Creating A New Song 创建一首新歌曲 - PRESONUS Quantum 4848 Owner's Manual

6
Studio One Profesional Quick Start
6.3 Creating a New Song
Configuring MIDI Devices 配置 MIDI 装置
6.2.2
2. If you do not see your device listed on the Start page when
you launch Studio One, click on the Configure Audio Devices
link in the Setup area to open the Options window.
如果你在启动 Studio One 时，没有看到你的设备列在
"Start " 页上，点击设置区域"Configure Audio Devices"链
接，打开"Options" 选项窗口。
In the Options window, click on the Audio Setup tab and
select your device driver from the pull-down.
在"Options" 窗口中，点击 "Audio Setup" 标签，从下
拉菜单中选择你的设备驱动程序。
From the External Devices window in Studio One, you can configure
your MIDI keyboard controller, sound modules, and control surfaces.
This section will guide you through setting up your MIDI keyboard
controller and sound modules. Please consult the Reference Manual
located within Studio One for complete setup instructions for other
MIDI devices.
在 Studio One 的"External Devices "窗口，你可以配置你的 MIDI 键盘
控制器、声音模块和控制面。本节将指导你完成对 MIDI 键盘控制器
和声音模块的设置。有关其他MIDI设备的完整设置说明，请查阅
Studio One 中的 "Reference Manual"《参考手册》。
If you are using a third-party MIDI interface or USB MIDI-controller
keyboard, you must install any required drivers for these devices
before beginning this section. Please consult the documentation that
came with your MIDI hardware for complete installation instructions.
如果你使用的是第三方 MIDI 接口或USB MIDI 控制器键盘，在开始
本节之前，你需要为这些设备安装任何所需的驱动程序。有关完
整的安装说明，请查阅你的 MIDI 硬件附带的文件。
If you do not have any MIDI devices, please skip to Section 6.3.
如果你没有任何 MIDI 设备，请跳到 6.3 节。
Quantum 4848
Owner'sManual
31