Table of Contents
Advertisement
The KPSC 12-pin header and the update jumper for the KP6 (and KPL) are located on the right side
of the keypad when facing front. These are covered when a trim plate is installed.
Note: The update pins on the KP6 are accessed from the side when the keypad is not installed.
3
KP6 Front View
KP6 Top View
KP6 Side View
1
2
3
1
Jumpered
pins
COMPONENT GUIDE
Keypad Update Port
OS UPDATE/RUN JUMPER -The pins are
1
jumpered when performing a firmware
update on the keypad. The jumper is
removed during normal operation.
2
KPSC PORT - 12-pin header for connec-
tion to KPSC source control keypad.
3
OS UPDATE PORT - Used to update the
KP6 and KPL keypad operating system
firmware. If an update is released, it will
be available online through the
Document Center on
www.russound.com. Look in the
"Firmware and Downloads" section under
Multi-Zone product type. The Advanced
Programming Cable is available from
Russound, Part #2500-521065.
INSTALLER
17
Advertisement
Table of Contents
