JETWAY 9BXAS Manual page 20

Power Management
PM Control by APM
Video Off Method
Video Off After
MODEM Use IRQ
Doze Mode
Standby Mode
Suspend Mode
HDD Power Down
Throttle Duty Cycle : 62.5%
ZZ Active in Suspend : Disabled
VGA Active Monitor : Enabled
Soft-Off by PWR-BTTN : Instant-Off
CPUFAN Off In Suspend : Enabled
Resume by Ring
Esc: Quit
F1 : Help
F5 : Old Values (Shift)F2 : Color
 Power Management:
saving and is directly related to the following modes:
Doze Mode , Standby Mode , Suspend Mode , HDD Power Down
There are four selections for Power Management, three of which have fixed mode settings.
Disable (default)
Min. Power Saving
Max. Power
Saving
User Defined

PM Control APM: When enabled, an Advanced Power Management device will be activated
to enhance the Max. Power Saving mode and stop the CPU internal clock.
If the Max. Power Saving is not enabled, this will be preset to No.

Video Off Method: This determines the manner in which the monitor is blanked.
V/H
SYNC+Blank
Blank Screen
DPMS

Video Off After:
power saving mode.
N/A
Suspend
Standby
Doze
: Disabled
: Yes
: V/H SYNC+Blank
: Stand by
: 3
: Disabled
: Disabled
: Disabled
: Disabled
: Enabled
↑↓→←: Select Item
Pu/Pd/+/-: Modify
This category allows you to select the type (or degree) of power
No power management. Disables all four modes
Minimum power management. Doze Mode = 1 hr. Standby Mode
= 1 hr., Suspend Mode = 1 hr., and HDD Power Down = 15 min.
Maximum power management -- ONLY AVAILABLE FOR SL
CPU'S. Doze Mode = 1 min., Standby Mode = 1 min., Suspend
Mode = 1 min., and HDD Power Down = 1 min.
Allows you to set each mode individually. When not disabled,
each of the ranges are from 1 min. to 1 hr. except for HDD Power
Down which ranges from 1 min. to 15 min. and disable.
This selection will cause the system to turn off the vertical and
horizontal synchronization ports and write blanks to the video buffer.
This option only writes blanks to the video buffer.
Initial display power management signaling.
When enabled, this feature allows the VGA adapter to operate in a
Monitor will remain on during power saving modes.
Monitor blanked when the systems enters the Suspend mode.
Monitor blanked when the system enters Standby mode.
Monitor blanked when the system enters any power saving mode.
IRQ 8 Break Suspend : Disabled
** Reload Global Timer Events **
IRQ [3-7, 9-15], NMI : Enabled
Primary IDE 0
Primary IDE 1
Secondary IDE 0
Secondary IDE 1
Floppy Disk
Serial Port
Parallel Port
F6 : Load Optimal Defaults
F7 : Load Standard Defaults
Figure 3-4
19
: Disabled
: Disabled
: Disabled
: Disabled
: Disabled
: Enabled
: Disabled