Screensaver - Panasonic TH-55SQ1W Operating Instructions Manual

■
[Current input]
Displays whether the input currently in use for viewing
is the (main) input set by switching input or the
backup one.
Setting conditions
The following table describes restrictions (available
combinations) on each setting item.
HDMI1
HDMI2
DisplayPort
DIGITAL LINK
Backup
DVI-D
SLOT
PC
USB
○: S electable for both Primary and Secondary.
: Selectable for either Primary or Secondary.
×: Not selectable for neither Primary nor Secondary.
Recall display
Pressing <RECALL> displays any of the followings.
●
When the main input is being used for viewing and
the operating conditions for the Backup Input function
are met.
HDMI1
Full
Backup mode OK
●
When the backup input, enabled by the operation of
the Backup Input function, is being used for viewing.
HDMI1
Full
Primary backup input
When the conditions for the Backup Input function
are met, the following screen is displayed.
Backup mode OK
Note
●
This menu will be greyed out and cannot be set under
the following conditions.
[Input search] is set to the item other than [Off].
•
(see page 63)
[Setup] - [Image settings] - [No signal image
•
settings] - [Display setting] is set to [On]. (see page
73)
Main
HDMI1
HDMI2
DisplayPort
PC USB
DIGITAL LINK
DVI-D
SLOT
○ ○
×
○ ○
[Power management mode] is set to [Input
•
detection]. (see page 69)
[SLOT power link] is set to [On]. (see page 88)
•
● When set to the USB input, the unit determines video
signals are interrupted by judging the USB memory is
not connected to the USB terminal.
● This function may not operate correctly depending on
the image playback device.

Screensaver

Alleviates the occurrence of afterimage when displaying
still images or images with 4:3 aspect ratio for a long
time.
[Screensaver] - submenu screen
Screensaver
Start
○
Mode
Wobbling
■
×
Screensaver settings
Screensaver operation
When the Screensaver is operating, the following 5
patterns are displayed full screen for 5 seconds each,
and it will be repeated.
Black → Dark grey → Grey → Light grey → White →
Light grey → Grey → Dark grey
To start Screensaver now
Select [On] in [Mode].
Select [Start] and press <ENTER>.
● The Screensaver will be activated.
Screensaver
Start
Mode
Note
●
If the following buttons are pressed while the
screen saver is operating, the screen saver is
cancelled.
Remote control: <RETURN>
Unit: <MENU (Unit)> <INPUT (Unit)>
<+ (Unit)> <- (Unit)>
<ENTER (Unit)>
●
When the display is turned off, the Screensaver will
be deactivated.
To set interval of Screensaver
Select [Interval] in [Mode].
Set [Periodic time].
●
Press
●
In [ENGLISH(US)] OSD language, [Periodic
time] is displayed as [SHOW DURATION].
2019/01/01 TUESDAY 10:00
Off
Off
2019/01/01 TUESDAY 10:00
On
to change the time by 15 minutes.
67
English