Tools And Parts You Need - Cisco 7500 Series Configuration Manual

Preparing for Installation
This chapter includes specific information about required tools and parts, safety guidelines, and
preparatory information required to ensure a successful installation of your Cisco 7500 series router.
Do not unpack the Cisco 7500 series router until you are ready to install it. Keep the chassis in the
shipping container to prevent accidental damage until you have determined where you want it installed.
Use the appropriate unpacking documentation included with your Cisco 7500 series router.
The Cisco Information Packet provides safety, and service, and support information, and is included in
the shipping container, together with any companion publications you specified on your order. Inspect
all items for shipping damage. If anything is damaged, immediately contact a customer service
representative.
Sections in this chapter include the following:
•
•
•
•
•
•
•

Tools and Parts You Need

Following are the tools and parts generally required to install your Cisco 7500 series router:
•
•
OL-5008-03 B0
Tools and Parts You Need, page 2-1
Safety Recommendations, page 2-2
AC-Input and DC-Input Power Guidelines, page 2-7
Plant Wiring Guidelines, page 2-10
Site Environment, Chassis Temperature, and Airflow Guidelines, page 2-12
Equipment Rack-Mounting Guidelines, page 2-15
Environmental Monitoring and Reporting Overview for the Cisco 7500 Series, page 2-22
Number 1 Phillips and 3/16-inch (0.476 cm) flat-blade screwdrivers; additional tools, parts, and
procedures listed and discussed in companion documentation
Rack-mount kit (hardware and accompanying documentation)
If you are installing the Cisco 7500 series router in a rack, you might also need the following tools:
Number 2 Phillips screwdriver
-
1/4-inch flat-blade screwdriver
-
Tape measure
-
Level
-
C H A P T E R
Cisco 7500 Series Installation and Configuration Guide
2
2-1