Cisco 7513 Overview - Cisco 7500 Series Configuration Manual

Chapter 1 Cisco 7500 Series Product Overview

Cisco 7513 Overview

Cisco 7513 Overview
The Cisco 7513 router supports multiprotocol, multimedia routing and bridging with a wide variety of
protocols and any combination of available electrical interfaces and media. Network interfaces reside on
interface processors that provide a direct connection between the two CyBuses in the Cisco 7513 and
your external networks. The Cisco 7513 has 13 slots: interface processor slots 0 through 5, Route Switch
Processor (RSP2, RSP4/4+, RSP8, or RSP16) slots 6 and 7, and interface processor slots 8 through 12.
The Cisco 7513 supports 11 VIPs, one for each interface processor slot.
There are bays for up to two AC-input or DC-input power supplies. The chassis will operate with one
power supply. Although a second power supply is not required, it allows load sharing and increased
system availability.
Because of agency compliance and safety issues, mixing AC-input and DC-input power supplies in the
Caution
same Cisco 7513 is not a supported configuration and should not be attempted. Doing so might cause
damage.
The Cisco 7513 is shown in Figure 1-10. The three front-panel LEDs indicate system and power supply
status, and LEDs on the RSP, interface processors, and power supplies indicate status.
Cisco 7500 Series Installation and Configuration Guide
1-15
OL-5008-03 B0