Table of Contents
Advertisement
EXCELL PRECISION CO., LTD.
E2 Zero value after power on is less than -10% FS.
JP105 on PCB board of AW, HW, FD, RW, TW) and GTW or JP5 on PCB board of
FB530:
If short circuit E1, E2 warning. If open circuit t no E1, E2 warnings
E4 Unstable zero return, unstable over 10 sec. Press
E6 Zero is too high when calibrating. (over internal value 350,000)
E7 Zero is too low when calibrating. (under internal value 80,000)
E10 The scale is not in level status.(only available with level detector equipment.)
- - - - - - For weight < -20d without tare or pretare device in operation.
E10 Level Switch (option)
Make JP2 on PCB board of FB530 to be open circuited. Then connect signal to CN1 on
PCB of FB530. CN1 is open circuited, display shows E10 after 2 seconds and all keys stop
working in the mean time. When CN1 is short circuited, display resumes and can continue
weighing. If you do not need level switch, make JP2 short circuited.
Chapter 2 General Operation Description
2-1 Backlight Function
Press
key to select the display backlight mode:
.
.
.
2-2 Weighing Mode
2-2-1 Units Selection
1.
After indicator is turned on, use
as the screen indicated.
2.
The selected unit will be memorized when you turn the indicator off. And the
memorized unit will appear after you turn on the indicator next time.
2-2-2 Zero Function
Press
key to re-zero the display with no load on the platter. When zero is set,
the (→0←) symbol will be displayed.
2-2-3 Tare Function
1. When the weight of the container is unknown (
Place the container on the platter, after stable and press
0201810X
"Auto Backlight" mode. When the weight is over 10d or any key is
pressed, the display backlight will be switched on. When the
weight returns to zero (the weight on platform is less than 10d),
the display backlight will switch off after 10 seconds.
Display backlight is on all the time.
Display backlight is off.
key to select a unit from kg, lb, tael or viss,
)
6
to leave E4.
key, the weight
ZSME300000292
Advertisement
Table of Contents
