EXCELL PRECISION CO., LTD.
beeper beeps.
Under Status in Preset Low Limit (preset single point only)
The BEEP, LCD mode should be fixed as follows:
Warning device setting
Set HI value and value of the beep, LCD mode should be fixed as follows:
When the weight equals to HI value, Relay Card open and the weight is accumulated.
Press CE key to dismiss the warning sound and the range of accumulated weight is
[000.000]~[999999].
Clear warning accumulation
Press
key first and then press
Accumulated data is cleared automatically under in following conditions
a. when shift among weight mode, counting mode and warning accumulation mode.
b. when shift the units
c. turn off the scale
LCD indication:
◆
To exit preset mode, please press
2. Recall Check-weighing Values
Press
Then press
Then press
Then press
3. Clearing Check-weighing Values
Press
key then press
Then press
Press
key then press
2-2-5 Totalizing
1. Weight Totalizing
Place goods on the platter, after stable and press
Then the display shows the total number of additions and the totalized weight value.
And the (M+) indication " " will flash on the display. The indicator will recover to show
0201810X
When over "Low Limit", the beeper beeps and
Whether stable or not, the beeper beeps and LCD indication is on
A
10d Low Limit
key then press
key again Recall "High limit value"
key again Recall "Beeper value"
key again Back to the beginning
key, and then press
key again Clear "High limit value" and "Beeper value"
key 6 times continuously Clear all values.
key to clear all accumulated data.
High Limit
key.
key Recall "Low limit value"
9
key Recall "Low limit value"
key to save the weight value.
ZSME300000292
is off