Connecting To The Power Supply - Haier XQG50-RC1000TXB Operational Manual

Joining the inlet hose to the washing machine
1. Connect the nut on the inlet hose to the connector on the water valve.
2. Tighten the nut to secure the hose
Drainage hose
The height of the drainage outlet must be 80cm ~ 100 cm. To prevent the drainage hose from
dropping off, fix it to the drainage hose clip at the back of the washing machine.
Use the drainage holder to keep the end of the drainage hose retained and prevent the outflow of
water. It is recommended that the length of the drainage hose not be increased; if an increased length
hose is required, please consult a serviceman.
cm (overextended hoses could lead to siphonage). Note:
in water and should be securely fixed and leak-free.

Connecting to the power supply

Before connecting to the power supply, check:
The socket is adequate for the maximum power of the washing machine (For safety, fuses in the
power circuit should be rated for no less than 15A).
The voltage should meet the requirement.
The power outlet should be capable of accepting the washing machine plug.
The washing machine must be earthed before use.
If the power socket is earthed, no need to use the spare earth cable.
If the power socket is not earthed, use the spare earth cable. Connect one end of the earth cable to
the terminal at the back of the washing machine, and make sure another end is earthed properly.
Caution: Never connect the earth cable to water pipes or heating pipes.
connector
The additional hose should be no more than 250
The drainage hose should not be submerged
nut