Haier XQG50-800TXB Operation Manual page 7

Maintenance
1. Turn of the water and electricity supply
after every wash. Open the door to pre-
vent the formation of moisture and odors.
If the washing machine is left idle for a long
period, drain any remaining water in the
machine and replace the drainage hose.
3. Clean the detergent compartment
regularly. For the detergent compartment
similar to figure (a), raise the compartment
slightly to remove and replace after cleaning.
Fig (a)
5. To prevent block-
ages to the water sup-
ply or the ingress of
contaminants, clean
the water inlet and in-
l e t w a t e r f i l t e r
regularly.
7. If the washing machine is left idle
for a long period turn off the water and
electricity supply and open the door
slightly to prevent the formation of
moisture and odors.
12
2. Unplug the machine during cleaning and
maintenance. Use a soft cloth dampened with
soapy liquid to clean the machine case and rub-
ber components. Do not use corrosive or abra-
sive chemicals or solvents.
4. Cleaning the Filter (once a month)
Press the lower edge of the filter compartment
cover to open; (Fig1-2)
Remove the filter by turning counterclockwise;
(Fig3)
Flash clean with running water;
Filter replacement is the reverse of removal. Cau-
tion: Attention shall be paid to ensure that the filter
is replaced correctly to avoid possible leakage.
fig.1 fig.2
6. If the machine is to be moved a distance location,
replace the vibration mounting locks which were re-
moved during installation as shown below.
Insert the bolts
Remove the back Remove the plastic
and rubber hoses.
plate. plugs.
Tighten the bolts with a Replace the back
spanner . cover.
Installation
Connection of water inlet hose and washing machine
Water drainage hose
= The height of the terminal of the water drainage
hose should be between 80cm-100cm, the water
drainage hose must be securely placed on the clip
on the back of the washing machine.
Use the water drainage support supplied as an
accessory for proper installation of the water drain-
age hose .fix the water drainage hose support with
waterproof sring.Do not use an excessively long wa-
ter drainage hose and contract the authorized tech-
nician if the water drainage hose needs to be
extended.the water drainage hose should not be ex-
tended more than250cm.(longer extension will result
in concurrent water inflow and outflow).The diam-
eter of the extension hose should be the same as
fig.3
the original hose.
caution:water drainage hose must not be immersed
in water.the original and extension hoses should be
tightly connected .
Connection of power supply
Check the following items before connection to the power supply.
==The socket conforms to the maximun power load(The maximum current load of the socket and
power supply cable should not be less than 15A)K
Power supply voltage conforms to the required value.
==The power supply socket and the plug of the washing machine are compatible,if they are not
compatible ,Refer to a washing machine technician or a Haier designated service point for power
cable replacement.The washing machine should be connected to an earth before use.
= Supplementary earth cable should not be necessary if the socket is connected to the earth.
= Supplementary earth cable should be installed on the upper back of the washing machine
andconnected to an earth if the power supply socket has no earth connection.
5