Installation Instructions
6.4 Mount Back Plate
1. For surface mounting, install back plate on the wall with the 3 screws (M4x20) and plugs.
Back plate
Figure 8
2. For switch box mounting, install the back plate on the switch box with 2 screws (M4x25)
and fasten it on the wall with 1 screw (M3.9x25).
Figure 9
NOTICE:
Place on a flat surface. Over-tightening screws may damage back plate
of the wired wall thermostat.
1 4 |
Back plate
Screw (M3.9x25)
Screws (M4×25)
Climate 5000 Series Gen 3 Wired Wall Thermostat (02.2022)
Screws (M4x20)
Switch box