installing batteries
Wall Mount - permanent
1. Remove the TSTBM-RRS--TW-A from the
subbase.
2. Mount subbase to the wall.
insTalling baTTeries
installing batteries for Temporary Wall
Mount or Table placement
1. Use the finger tab on the back of the remote to
remove the battery door.
Revised 02-13
Inside View
of Subbase
of Remote
Sensor
Subject to change without prior notice
TSTBM-RRS--TW-A
2. Once you have removed the door from the back
of the remote, insert 2 AA Alkaline batteries and
replace the battery door.
inserting batteries for permanent
Wall Mount
1. Remove the TSTBM-RRS--TW-A from the
subbase. The TSTBM-RRS--TW-A is held on the
subbase by a plastic tab on the bottom of the
remote sensor. Push in with a small flat head
screwdriver to remove the TSTBM-RRS--TW-A
from the subbase.
Bottom of
Remote Sensor
6 720 220 377
5